Start-Up List For Your Evaporator
READ MORE
At the rear of the preheater, the lower left pipe is where your cold sap will enter the system. The hot sap will exit the system and go to the float box at the upper right. The vent can be extended up from the upper left, the lower right can be used as a drain. If you desire, you can cap the upper left and the lower right and you can then branch the drain and vent off elsewhere else in the system.
2 Comments
Ian Mollins
Hi there
I have a 2×6 lapierre /Waterloo /small oil fired evaporator , it does not have a steam hood , my father and I are considering a sap Preheater and was
Wondering if your company could make one for our evaporator , we are not sure what the best route to go with either copper or stainless ? and also does the drip tray work pretty efficient ? What approximately would be the cost ? I’m am not apposed to a steam hood but My father really likes to keep an eye on things ect ,,, unless you have a raised hood available maybe? Any info or advice would be appreciated
Thank you
Ian
Angela
The drip tray on this preheater is designed to drain into hood gutters. If you are not using a hood, we do have an alternate solution. The typical stainless steel preheaters which are compatible with 2×6 pan sets run about $1200. May I have a one of our maple specialists give you a shout to discuss further? Otherwise you can give our shop a shout at your convenience. (920) 202-4500.